How do I set my touchpad if I have solar power?





Please ensure you have set your:

  • Date & Time

  • Set Temperature

  • Mode

  • Your filtration cycle is pre-set

(Please refer to your SV Series User Manual to adjust these settings)


To optimize your solar power during the day, set your sleep timers to begin at night and end in the morning.

 Sleep Mode:

If you wish to run your spa during certain times of the day (eg: solar power, avoid peak power times)

Hold down the Up & Down arrow

Press the arrow Up until you get to SNZE

Press SNZE the OK

Arrow down until you see 1.SNZ press OK

Day - arrow down or up to set the days of the week you want the sleep timer to run the press OK

BGN- time you want sleep timer to start then press OK

END- time you want to finish your sleep time

Then press OK to save


NOTE: Please refer to page 24 of the SV series user guide attached) During the sleep time your filtration and heating is disabled.


Was this article helpful?
3 out of 3 found this helpful
Have more questions? Submit a request



Article is closed for comments.