Installation
- How do I set up my new spa pool?
- How do I install my heat pump?
- How many amps does the SV3 controller require and work with my spa?
- How can I increase my new spa heat up time?
- How do I wire my Hot Springs Spa?
- When will my Ace Sanitizing System be installed?
- Do the pipes for my heatpump need to be insulated?
- How do I assemble my spa steps?
- What is the water capacity for your 1.5 deep swim spas?
- Who installs my new spa heat pump?
- Do your spas come with a built in isolation switch?
- How do I measure the space required for my concrete slab?
- What is the measurement for the lip on a vortex spas?
- Where do I place the conduit for my vortex swim spa?
- How do I set up my SpaNet touchpad?
- How do I set up my HotSprings spa touchpad?
- Do I need an isolation switch for my spa?
- How do I install my vortex headrests?
- How do I install my heat pump to the SV Mini Controller?
- What is three phase power and can I use it?
- What is single phase power?
- The base of my spa was cracked upon delivery, will this effect my spa?
- Who drills the hole into the cabinet for the power plug?
- How long do I need to let my concrete slab set for?
- What power source is required to connect my Spanet Heat Pump to my spa?
- How much clearance should I leave to put decking around my spa?
- Will the delivery team help set up my spa?
- What is the recommended foundation or base for the spa?
- How do I hard wire my spa?
- Can I leave my new spa outside in the open for a number of weeks?